熱交換機組運行中的常見問題及處理:
熱交換器的一次溫度正常,二次供水的溫度較低,檢查系統的閥門是否開啟,檢查過濾器是否清潔。
新投入的換熱器組,給水溫度正常,二次給水溫度正常,如果有些用戶不熱,除了檢查循環泵的運行電流和頻率外,還要檢查地溫入口過濾器,調整二次管網的水力平衡,很麻煩,但一次調整一次。
二次供水溫度正常,總供暖面積不增加時,部分用戶不熱,檢查循環泵的運行狀況是否變化,如電流、頻率。檢查二次供給回水壓差與以前相比,二次供給回水壓差明顯小于以前,換熱器結垢的可能性很高,需要清洗換熱器。熱工用戶經常放水,或二次管網跑、冒、滴、漏,系統頻繁補水,加快了換熱器的結垢,縮短了換熱器清洗周期,熱工用戶盡量排除上述情況。
設備嚴格要求一次網回水溫度,系統一次網回水溫度超過50度時,發生跳躍、城市停溫事故。熱交換站二次供水正常,一次供水溫度接近50度(熱交換單元設計一次供水溫度為46度),為了保證每一次設備的安全運行,熱公司要求檢查供水溫度過高的單元,這些熱交換單元的管理者要求清洗一次供水溫度達到50度的單元熱交換器,在單元沒有清洗或者一次供水沒有下降之前,為了保證縣里整體的正常供暖,該單元的二次供水溫度不能上升。
總結:熱交換器的結垢是影響供暖質量的突出問題,各熱交換站管理者高度重視。熱交換器清洗后,避免機組運行期間的二次系統頻繁補水,避免跑、冒、滴、漏現象,降低系統補水率,保證軟水器所需的粗鹽量,確保補水水質,做好上述工作可有效延長熱交換器的清洗周期,節約運行成本,保證居民的正常供暖。