該系統的預處理設備為多介質過濾器,采用均勻石英砂和無煙介質作為過濾材料。主要作用是濾除原水帶來的微細顆粒、懸浮物、膠體等雜質,保證生產水質符合RO裝置進水水質要求,保證出水(污染指數)小于4。
(1)反洗:
關掉過多介質過濾器,關閉進出口閥門,打開排氣管和反洗排氣管,打開反洗泵,緩慢打開反洗進水閥,調整反洗量,大約200m3/h,觀察反洗量出口是否有無煙煤流出,在無煙煤不流出的基礎上反洗15分鐘。
(2)空氣清洗:
反沖洗后的空氣沖洗的目的是去除濾料上的污垢,提高反沖效果。反洗結束后,關閉反洗進水閥,打開底座,將水排入鏡面上,即濾料無煙煤上方10cm處,關閉底座排水,打開羅茨鼓風機和進水閥,控制進氣強度。特別是觀察鏡下無煙煤層處于上下懸浮狀態,使多介質過濾器過濾料不會(huì )劇烈上下攪動,避免出現亂層現象。
反沖操作5分鐘后,按上述方法沖洗排水閥,再反沖操作5分鐘。
(3)清洗:
在投入使用之前進行沖洗,主要是恢復接觸過濾和深度過濾的效果,以保證多媒體出水的水質,即SDI(污染指數)≤4。其具體操作方法是:打開排氣閥,進水閥門,沖洗排水閥,打開水泵,調節進水流量(采用正常工作流量正洗),沖洗10分鐘,檢查濾網出水濁度。SDI試驗中濁度小于0.5的,可以繼續沖洗;
為確保后續系統的正常運行,可對多個濾網進行依次清洗,具體步驟為:反洗,氣洗,沖洗。上述是清洗多介質過濾器的方法。